|
Your Company |
|
Company Name:
|
|
|
Mailing Address:
|
|
|
City, State, Zip/Postal Code:
|
|
|
Contact Person:
|
|
|
E-Mail Address:
|
|
|
Telephone:
|
|
|
|
|
Size |
|
Pipe Size of Application (Inches)
Nominal pipe size (I.D.)
|
|
|
Installed Length (Inches)
Dimension between mating flages. Also known as: Flange-to-flange, OAL or Takeout.
|
|
|
|
|
|
Flowing Medium |
|
Flowing Medium
Indicate fluid being piped. Refer to our "Chemical/Rubber Guide" for elastomer compatibility.
|
|
|
Type of Medium
Indicate if liquid, gas, slurry, solids, etc.
|
|
|
Temperature of Flowing Medium (F)
Indicate both operating and maximum temperatures at the expansion joint
|
Op.
Max.
|
|
Note: See Table: "Comparative Properties of Typical Proco Products, Inc. Elastomers" |
|
|
|
Pressures |
|
Operating Pressure of the System
Actual pressure in which system works in normal conditions (use PSIG and "Hg)
|
+ -
|
|
Design Pressure of the System
Highest/most severe pressure expected during operation (use PSIG and "Hg)
|
+ -
|
|
Surge Pressure of the System
Increased pressure due to pump starts, valve closings, etc. (use PSIG and "Hg)
|
+ -
|
|
Test Pressure of the System
Hydrostatic test used to demonstrate system capability (use PSIG and "Hg)
|
+ -
|
|
Type of Pressure
Constant, intermittent, shock, pulsating, etc.
|
|
|
|
|
|
Movements |
|
Axial Compression
In inches as a result of pipe extension-expansion
|
|
|
Actual Extension
In inches as a result of pipe contraction
|
|
|
Lateral Deflection at Joint
In inches
|
|
|
Angular Movement at Joint
In degrees
|
|
|
Torsional Movement at Joint
In degrees
|
|
|
|
|
|
Miscellaneous |
|
Pipe Flange Drilling
Indicate specific standard such as: ANSI,DIN, JIS, B5, Navy.
If special, provide: Flange O.D., Bolt Circle, Number & Size
of Holes
|
|
|
Mating Pipe Flange Thickness
In inches
|
|
|
Location of Joint Installation
Indoors or outdoors
|
|
|
Retaining Rings
Are required on all installations. Reusable, they need not be ordered with replacement or spare expansion points
|
Yes No
|
|
Control Unit Assemblies
Are recommended for use in all expansion joint applications. Control units must be used when piping support or anchoring is insufficient
|
Yes No
|
|
Hydrostatic Test of Joint Required by Manufacturer of Product |
Yes No
|
|
Quantity Required |
|
|
|
|
|
Comments
|
|
|
|
|
|
|